Ranger Mods

Hi how's it going guys? How can I fix / reset "Pre-collision assist not available" warning? I knocked my right side bumper on a pole and one side of the sensor was sightly pushed inside. I have since had it taken out and straightened the bent out and refitted it all back as per before, and in case the warning still persist, what steps i should consider taking instead of replacing it with a new sensor which will cost me an arm.
Advice appreciated guys.
Cheers.

There is a procedure to adjust the module and a Calibration that can be done in Forscan. Have a look at these two threads for info. The second one has instructions for adjustment. If you do a search for CCM there are more threads.

https://www.saeb.net/viewtopic.php?f=12 ... CCM#p14213

https://www.saeb.net/viewtopic.php?f=12 ... CCM#p13709