Page 1 of 1
PX3 KOLO (Key on Lights On)
Posted: Tue Jun 15, 2021 7:15 pm
by Bamtech
Hi all,
Setting up a mine spec ute, is there a way with forscan to have headlights come on with ignition? Looking to avoid fitting a KOLO module.
Re: PX3 KOLO (Key on Lights On)
Posted: Tue Jun 15, 2021 7:39 pm
by Lincolnland
Leave the headlight switch in the on position?
Re: PX3 KOLO (Key on Lights On)
Posted: Tue Jun 15, 2021 7:49 pm
by Bamtech
Doesn’t cut it for mine sites mate
Re: PX3 KOLO (Key on Lights On)
Posted: Tue Jun 15, 2021 11:25 pm
by CatHerder
I assume you don't care about tail lights?
There is a DRL LAMP CIRCUIT USAGE entry for the BCM. By default it is set to DRL ONLY on an XLT/WT. I'm unable to check, but It's possible that LOW BEAM (or similar) is an available option.
Edit:
There is a DAYTIME RUNNING LAMPS entry too, which is set to DEDICATED DRL for an XLT.
Good luck.
Re: PX3 KOLO (Key on Lights On)
Posted: Mon Jun 21, 2021 5:51 am
by saeb
Enable DRL and set low beam as DRL lights.
Also enable use parkers with DRL so the rear taillights are on.
Pretty sure the base cluster should support the DRL menu to support this.