Ranger Mods

Hey,

is there a code to be able to turn stability control off when turning traction control off? my px2 XLT only disables traction control.

regards

No, hold the traction control button down for about 10 seconds. The light will flash and allow the car to slide very sideways around the corner.

Be careful...

My new zealand model blinks after ten seconds but the stability control is still enabled, any ideas?

Read through page 136-137 of your Vehicle manual. It explains how and what it does.

Basically you want the very last sentence, if it does not work as expected then you may be expecting something to happen that we do not understand.

This is the last few sentences of page 137;


4-wheel drive vehicles
Note: All the stability control (ESC)
functions are reactivated when 2H position
is selected.
Transfer shift switch in
4H position:
• Press and hold the switch for one
second to deactivate Engine Traction
Control, Trailer Stability Control and
ESC. Hill Descent Control, Hill Start
Assist and Brake Traction Control
remain active.
Transfer shift switch in
4H or 4L position:
• Press and hold the switch for five
seconds to deactivate Engine Traction
Control, Trailer Stability Control and
Brake Traction Control. Hill Descent
Control and Hill Start Assist remain
active.
Transfer shift switch in
2H position:
• Press and hold the switch for one
second to deactivate Engine Traction
Control, Trailer Stability Control and
ESC. Hill Descent Control, Hill Start
Assist and Brake Traction Control
remain active.
• Press and hold the switch for five
seconds to deactivate Engine Traction
Control, Trailer Stability Control and
Brake Traction Control. Hill Descent
Control and Hill Start Assist remain
active.