Page 1 of 1
Splash warning screen on sync 3
Posted: Tue Jul 10, 2018 7:42 pm
by Flashwatches
Is it possible to get rid of the warning splash screen that comes on when you start. I cannot find it in the menu and wondered if there was a quick fix.
Sent from my SM-G950F using Tapatalk
Re: Splash warning screen on sync 3
Posted: Mon Jul 16, 2018 9:58 pm
by saeb
Never seen it so I have no idea. It's probably to do with the country code that the unit is set on for your region so in essence you could change that to another country but may lose other functions for your country.
Re: Splash warning screen on sync 3
Posted: Mon Jul 16, 2018 10:08 pm
by Flashwatches
saeb wrote:Never seen it so I have no idea. It's probably to do with the country code that the unit is set on for your region so in essence you could change that to another country but may lose other functions for your country.
Thanks, I was wondering why I haven't seen anyone else asking about it on the internet. I will have to go through the settings again and see if I can figure it out.
Sent from my SM-G950F using Tapatalk
Re: Splash warning screen on sync 3
Posted: Mon Jul 16, 2018 10:13 pm
by saeb
In Forscan ( latest version ) select your correct sync version and go to Country Code or whatever it is called. Make a note of it first or better, back the module up first, then change it to AS, write, ignition off for a few minutes and see what happens. This could or could not affect your emergency dialling or other international functions though.
Re: Splash warning screen on sync 3
Posted: Tue Jul 17, 2018 12:28 am
by Flashwatches
saeb wrote:In Forscan ( latest version ) select your correct sync version and go to Country Code or whatever it is called. Make a note of it first or better, back the module up first, then change it to AS, write, ignition off for a few minutes and see what happens. This could or could not affect your emergency dialling or other international functions though.
Thanks, I'll give it a go [emoji3]
Sent from my SM-G950F using Tapatalk