Trailer Tow Module and Reverse Sensors - Forscan configurable ?
Posted: Sat Jul 04, 2020 7:14 pm
Hi All,
I’ve got a 2017 XLS and am just about to fit a 2014 XLT rear step and tow bar. Questions are...
Can I use the Sensors from the XLT bar or will I have to swap them over with my factory ones? I wasn’t sure if the sensors run on a single electrical rail and are serialised or individually wired back to the sensor module?
I think I need to get a DG9T19H517AFK1T which is the Ford trailer wiring kit with module... Am I able to install this myself and enable using forscan ?
Cheers,
Evan
I’ve got a 2017 XLS and am just about to fit a 2014 XLT rear step and tow bar. Questions are...
Can I use the Sensors from the XLT bar or will I have to swap them over with my factory ones? I wasn’t sure if the sensors run on a single electrical rail and are serialised or individually wired back to the sensor module?
I think I need to get a DG9T19H517AFK1T which is the Ford trailer wiring kit with module... Am I able to install this myself and enable using forscan ?
Cheers,
Evan