Ranger Mods

Hi All,

I have a Provent 200 catchcan almost new, however i dont have the hoses or bracket to install. Ive tried multiple vendors, to purchase, but everyone only sells the complete kit.

Any suggestions?

cheers
Geoff

I mounted my Provent directly the the panel in front of the air filter beside the washer bottle (I think the PS oil reservoir used to be mounted here on PX1/2) using the bracket that comes with the Provent. Used the existing PCV hose to connect to the Provent after trimming a bit off. Used a cut down Ford Festiva upper radiator hose (Supercheap-Mackay PN:CH2267) to connect from the Provent to air intake.

The top of the Provent can sit proud of the front engine bay plastic panel as the bonnet is nicely contured at this point. This will leave room to connect and run a drain hose (https://www.ebay.com.au/itm/262611653132) down to area in front of the DSF tyre.

The extra parts were about $40 from memory.

geoffmc wrote: ↑Wed Feb 10, 2021 9:04 pm Hi All,

I have a Provent 200 catchcan almost new, however i dont have the hoses or bracket to install. Ive tried multiple vendors, to purchase, but everyone only sells the complete kit.

Any suggestions?

cheers
Geoff

Hi
I get my Provent gear from Western Filters in Sydney by mail. Great to deal with. They have all the bits and pieces here:
https://www.westernfilters.net.au/prove ... ing&page=1
(not sure if I did that right, again
https://www.westernfilters.net.au/prove ... ing&page=1
Remember that there are a few choices with brackets, locations to mount, which changes the hose configuration needed. Also there is a filter replacement / modification kit to update the original versions of the catchcan.
Good luck with it.
Cheers
PP