Ford Ranger 2.2 Limited UK (pre face lift) 2013 built SA
Posted: Thu Dec 26, 2019 7:00 am
Merry Xmas everyone!!!
Im wondering if anyone could help me with issues I have with my ranger, I've had a good read through the forum and found bits and pieces information that was relevant to my problems but need some more help.
I started off with putting LED combined fog and DRL onto the truck with no issues and internal lamp changes to LED, changed the entertainment system.
After a month I decided to put some plug and play HID, at first it caused a fault with the drivers side low beam and I took it to a garage to reset and then it worked fine for a few months. Then it stopped working again with only 7v only going through to the low beam, I checked every fuse and connection to ground, swapped the units around etc and couldn't reset the BCM.
The entire dashboard also stopped working completely (this is my fault as I think i crossed ground to live) and I located the the fault to a relay which i changed for new and everything appears to be working.
Then I tried to reset the BCM, IPC etc etc and basically think i've messed something up as I have lots of faults which I cannot clear.
Ive read about the FET BCM and aware now that I will have to change but I need to sort the other issues first before going any further and completely lost on what to do now.
I've attached the codes and any help would be very appreciated.
Many Thanks again
Gavin
Im wondering if anyone could help me with issues I have with my ranger, I've had a good read through the forum and found bits and pieces information that was relevant to my problems but need some more help.
I started off with putting LED combined fog and DRL onto the truck with no issues and internal lamp changes to LED, changed the entertainment system.
After a month I decided to put some plug and play HID, at first it caused a fault with the drivers side low beam and I took it to a garage to reset and then it worked fine for a few months. Then it stopped working again with only 7v only going through to the low beam, I checked every fuse and connection to ground, swapped the units around etc and couldn't reset the BCM.
The entire dashboard also stopped working completely (this is my fault as I think i crossed ground to live) and I located the the fault to a relay which i changed for new and everything appears to be working.
Then I tried to reset the BCM, IPC etc etc and basically think i've messed something up as I have lots of faults which I cannot clear.
Ive read about the FET BCM and aware now that I will have to change but I need to sort the other issues first before going any further and completely lost on what to do now.
I've attached the codes and any help would be very appreciated.
Many Thanks again
Gavin