2018 Everest 2.0; restoring from As Built (from Ford Motorcraft Vin Search) but missing two IPMA module addresses
Posted: Tue Jun 07, 2022 10:31 pm
Long story short; I did not back up my settings in Forscan and now I have adaptive cruise errors and a possible driving safety issue. I have been trying to get back to factory settings. The dealer is not very helpful so I am trying to sort this on my own. I downloaded the As Built file from the ford motorcraft site, and went line by line restoring all settings. However, one of the modules in which I have suspected I have a misconfiguration is also one that has two additional addresses that are missing from the AB file.
IPMA 706-05-01
IPMA 706-05-02
Perhaps someone could offer me some direction, or if you take pity on my stupidity perhaps even a screenshot of your IPMA settings in Forscan (assuming you have a 2018, with adaptive cruise, or possibly a 2019 may be the same). Or maybe you have an As Built file that is better that the one on the ford motorcraft site. I have googled the addresses, and checked all the spreadsheets of mods that I can find, and can not find any reference to these module addresses.
Your help is much appreciated!
Dan
IPMA 706-05-01
IPMA 706-05-02
Perhaps someone could offer me some direction, or if you take pity on my stupidity perhaps even a screenshot of your IPMA settings in Forscan (assuming you have a 2018, with adaptive cruise, or possibly a 2019 may be the same). Or maybe you have an As Built file that is better that the one on the ford motorcraft site. I have googled the addresses, and checked all the spreadsheets of mods that I can find, and can not find any reference to these module addresses.
Your help is much appreciated!
Dan