Ranger Mods

Hi All,
PX XLT 2013…
Driver’s window operates in non-automatic mode only (both switch positions produce only non-auto mode).
All possible manner of resets tried, including holding down with and without swearing, done it many times before, no joy now though. I note that the first time the issue showed, the window refused to move at all, stuck, but then freed up. Battery been off many times since.
Is the fault:
In the PCBs in the switch panel? Replace it? (It has got wet at times but I have stripped the switches: no sign of damage, cleaned them up).
In the door motor mechanism? Are there position sensor copper fingers like the HVAC sensors?
In the BCM?
Just want to know where to start looking!
Have had past issues on other doors with water ingress to motors.
Cheers,
Dave

Would probably look at the last post on your thread over here https://www.newranger.net/forums/viewto ... cbfe547ffa
Personally, I have nothing else.

Forgot to thank you on this! Apologies. Been unable to work on it for awhile whilst auto box was being fixed and fixed and fixed..