Hi
Please disregard. Obviously didn't allow enough time for sync 3 to update as all working now thanks.
Have tried changing Splash Screen on my PX3 Ranger to Raptor and Ford Performance and they seem to work when i write the changes but as soon as I disconnect from vehicle and start the engine they do not retain. I now have no splash screens at all. If I go back into the module and reload the APIM it is showing as being changed to the correct screens either Raptor or Ford Performance but no splash screens actually display.
Any idea's
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Help Needed
-
kencooper965
- New Member
- Posts: 3
- Joined: Sat Aug 27, 2022 7:02 am
- Location: Hunter NSW
- Model Of Vehicle: RANGER XLT PX3
- Year Of Vehicle: 2020
- Forscan Dongle Type: SAEB Forscan Dongle WIN10
- Has thanked: 3 times
-
saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
Good you sorted it but if you have the issue again then best way is either go to service functions and do an APIM reset which will soft reset the unit or leave the ignition off for 2 minutes with ignition off and open so it has time to shut down completely.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic