Ranger Mods

May also find this useful for the Lightforce switch wiring info/how to pull apart your lower dash section.

*be careful with the clips I guess, a workmate fitted his over the weekend and said the trims are tight and he broke one of the clips

The PX 3 come with the USB port on the RHS. I am having trouble removing the wiring from this port. Havent seen a connector like this before and it wont budge. Any ideas please?

A hammer?

Are you sure is not meant to be sealed and the plug being on the other end of the lead?

Not sure Stewart. Its something I have never come across before. I does wriggle but thats about it.

Wazza430 wrote: ↑Sun Apr 28, 2019 2:40 pm The PX 3 come with the USB port on the RHS. I am having trouble removing the wiring from this port. Havent seen a connector like this before and it wont budge. Any ideas please?

Check the attached pic, you sure this isn't a tab that needs to be levered with a flat screwdriver to release?

Your right mate it does lift up but also on the bottom. A very tight fit but once released it was easy. Thanks for all the input.

All good Wazza, still haven't gotten around to installing mine yet haha!

Just fitted mine, bugger of a job.
Trim panels very hard to remove as well as the usb cable as stated above.
Best advice is just follow the instructions provided and persivere.