Ranger Mods

Hi All,

Just to advise that PX3 and Everst UA2 Remote Start Kits are now available. $280 supplied and fitted, $250+ postage supplied.

There will be 2 Forscan changes to be made and all up estimated installation time between 10 to 15 minutes.

Added to the store > https://www.saeb.net/wp/product/remote- ... 2-everest/ <

SAEB

I only just purchased a kit from the US 3 weeks ago, and have now found out yourself and RedTek now make them too...

I think the US one needs the same Forscan changes, can you please let me know which two items you are modifying? My heated seats seem a bit inconsistent at the moment. I've enabled remote start in the IPC module, but the seats and climate control options are still greyed out. Any ideas?

Thanks for any help you can offer.

Send me saved IPC and FCIM asbuilt files and PM them to me, or post here, either or.

Everything seems fine.

Early PX3 FCIM, heater control panel, does not support the other 2 greyed out menus so disable them if you want.

It will always run in auto mode for climate on that vehicle no matter what, unless you update the FCIM firware which I will not do again as I killed one and had to revive on the bench. But at least after doing so his early PX3 does support the menus.

You gain noting from them anyway as setting to manual is not what you want.

Seats and climate will do as they do but certain factors will determine what happens. Middl point is around 22 degrees, colder then heater and seats will come on to an extent, colder then hotter and hotter..... Above then the aircon will come on. If the battery has low state of charge then this will also cause the seats to not come on or run at very low heat, I have experienced this first hand. Once SOC was up to scratch then it all worked perfectly.

Hi, i have a 2020 px3 with that trac electronics auto windows and mirror module. Would this be fine to have with each other? Also lock unlock lock slightly retracts all windows. Will this put to much strain on the battery when remote starting?

Cheers

Phillwehbe89 wrote: ↑Fri Aug 28, 2020 10:40 am Hi, i have a 2020 px3 with that trac electronics auto windows and mirror module. Would this be fine to have with each other? Also lock unlock lock slightly retracts all windows. Will this put to much strain on the battery when remote starting?

Cheers

Just use the lock lock lock option instead and turn off beep on double lock press.

LUL will work though, windows so come down a little then rise again once the vehicle starts. They do on the Trac window module anyway.

hi i just purchased the remote start for my px3. I got a email with instructions but its for the dongle. Will instructions for installation and forscan come with the package?

Phillwehbe89 wrote: ↑Sat Oct 24, 2020 10:16 pm hi i just purchased the remote start for my px3. I got a email with instructions but its for the dongle. Will instructions for installation and forscan come with the package?

Email sent.