Ranger Mods

Hi Everyone,

Is there a way to monitor the crank position sensor using Forscan?
And the Camshaft position sensor?

I would like to monitor them using the oscilloscope function.

Does any other software do this like OBDlink or Torque, etc?

I have found the camshaft to crank sync PID but that only gives a Yes or No value.
And it only shows a No.
Engine starts and runs no problems.

If the PID is not in there then no you cannot add it to Forscan.

Quick search of my docs means I do not believe what you are looking for is an available PID full stop.