Page 1 of 1
OBDII interface ex Toyota will it work with Forscan
Posted: Wed Nov 15, 2017 12:17 pm
by Evernew1
Hi Andrew
First post on your forum
I have this cable I used with Techstream software on my old Prado. It worked fine.
Will it be OK for Forscan ? From the little research I have had time to do, I think not.
http://www.ebay.com.au/itm/253012820868
Re: OBDII interface ex Toyota will it work with Forscan
Posted: Wed Nov 15, 2017 1:30 pm
by saeb
Andrew?
That cable may well work.
Try the different passthrough interfaces in Forscan as it does support the J2534 protocol. Select the J2534 connection type in the connection settings and see what happens.
If you can see the IPC then it is working correctly.
Re: OBDII interface ex Toyota will it work with Forscan
Posted: Wed Nov 15, 2017 2:46 pm
by Evernew1
Thanks Stewart and sorry don't know where the Andrew came from.
Re: OBDII interface ex Toyota will it work with Forscan
Posted: Thu Dec 07, 2017 1:40 pm
by Evernew1
Ok I have finally gotten round to trying this J2534 adaptor and it does connect, however it appears I can't see all the modules I am supposed to.
- Forscan with MVCI.png (197.36 KiB) Viewed 78 times
- Forscan with MVCI.png (197.36 KiB) Viewed 78 times
Still some config settings to play around with but don't hold out much hope
Re: OBDII interface ex Toyota will it work with Forscan
Posted: Thu Dec 07, 2017 6:55 pm
by saeb
It does not appear to support the MSCAN interface.
Buy one of these, cheap and will access all modules
viewtopic.php?f=56&t=393
Re: OBDII interface ex Toyota will it work with Forscan
Posted: Fri Dec 08, 2017 3:55 pm
by Evernew1
Yep thanks Stewart, will get one of them.