Page 1 of 1
DTCs won’t reset/clear
Posted: Sun Dec 18, 2022 8:48 pm
by jackos_one
Need some help from the brains trust…
I’ve had some fault codes that I haven’t been able to clear for a while now, and assume it’s from me fiddling around with asbuilts…
Pic attachEd
And unfortunately I don’t have an saved profile to be able to load asbuilt before the issues arose.
Main ones that I need help with are
Bcm b115e - camera module - camera works but have lost active steering lines
TRM u2100 - initial config not complete - can’t figure this one out, has me stumped as only recently started to appear, and ford installed towbar etc years ago
IPC u0199
IPC u023a
Please help!
Thanks gents
Re: DTCs won’t reset/clear
Posted: Mon Dec 26, 2022 7:34 pm
by saeb
Go to asbuilt on APIM, BCM and IPC and load factory AB. Load and write all for each module, clear DTCs and start again.
Ignore the TRM, although it can be sorted there is no asbuilt as such anyway and can be ignored. One step at a time.
- 2022-12-26 19_31_44-.png (27.97 KiB) Viewed 119 times
- 2022-12-26 19_31_44-.png (27.97 KiB) Viewed 119 times
Re: DTCs won’t reset/clear
Posted: Sat Dec 31, 2022 5:31 pm
by jackos_one
Thanks Stewart, I loaded factory AB for BCM and APIM, however when I went to do IPC, a warning popped up saying “number of blocks in file of module doesn’t match…” continue yes/no.
Is it safe to click yes and continue?
Asking, as this didn’t happen with the other modules and wasn’t sure.
Look forward to your reply.
Happy new year!
Re: DTCs won’t reset/clear
Posted: Sat Dec 31, 2022 7:47 pm
by saeb
Will be fine, just load and write, you are just running old firmware is all.
Re: DTCs won’t reset/clear
Posted: Sun Jan 01, 2023 4:18 pm
by jackos_one
Hi mate,
Thanks for your help with this, truely appreciated.
Am having trouble loading factory AB for IPC, warning box says “incompatible configuration” due to blocks 2 and 6 failing.
Any ideas?
Cheers
Re: DTCs won’t reset/clear
Posted: Sun Jan 01, 2023 4:43 pm
by saeb
Clear all DTCs and see if there are any.
Re: DTCs won’t reset/clear
Posted: Mon Jan 16, 2023 11:44 am
by GenieMan
I am also getting code U2100, what do I need to change to clear?
===TRM DTC U2100:00-2F===
Code: U2100 - Initial Configuration Not Complete
Module: Trailer Module
I have an XL but installed the dual screen cluster so I assume missing somthing from the car that that the cluster came out of.
EDIT:
same for
===IPC DTC U023A:00-0A===
Code: U023A - Lost Communication With Image Processing Module A
Module: Instrument Panel Control Module