Page 1 of 1
wiring harness rubbing on 3.2
Posted: Tue Oct 13, 2020 1:57 pm
by hoges
3.2 px. The harness running "over" cam chain cover where it attaches to engine block rubs and eventually shorts wiring causing engine to stall & other issues. So check and fit a protective sleeve over harness. it's easy to see if you pop front plastic engine cover. the timing cover is black pressed steel.
Re: wiring harness rubbing on 3.2
Posted: Tue Oct 13, 2020 10:52 pm
by RossPat
Yes, saw that but mine don't run over it.
Re: wiring harness rubbing on 3.2
Posted: Wed Oct 14, 2020 10:45 pm
by hoges
Ok you must have got lucky. The ones I have seen all are rubbing. Definitely worth checking though.
Re: wiring harness rubbing on 3.2
Posted: Fri Oct 16, 2020 1:09 pm
by Bala1
Checked mine and it was rubbing so long term would have caused issues. Perhaps they changed is for the 2018.
Re: wiring harness rubbing on 3.2
Posted: Mon Oct 19, 2020 5:48 pm
by saeb
Most later models I have looked at seemed to have had a revision and did have sufficient space. Not sure the exact date the revision was made.
Re: wiring harness rubbing on 3.2
Posted: Mon Oct 19, 2020 6:08 pm
by Bala1
Mine is Dec 16 build.