Hello from Victoria
Posted: Mon Oct 15, 2018 1:49 pm
Hi guys,
New to the forum I have my second PX Ranger that i justed picked up as a runout, a 2018 PX2, 3.2l manual this time as i really didnt like the previous auto.
In the process of setting it up with all the usual stuff, 2" lift just installed, 285/70/17 BFG Km3 just fitted to a set of black rims.
Kutsnake flares this week, Barwork is just getting finished and hope to install in the next few weeks.
I would like to know what is a good scantool to run for this vehicle to check faults and also change the stupid stop/start from resetting? I dont want to install anything permenant really
With a few more kms the exhaust and snorkel will go on with a Dyno tune, not sure what i am going to do with the DPF yet.
Glenn
New to the forum I have my second PX Ranger that i justed picked up as a runout, a 2018 PX2, 3.2l manual this time as i really didnt like the previous auto.
In the process of setting it up with all the usual stuff, 2" lift just installed, 285/70/17 BFG Km3 just fitted to a set of black rims.
Kutsnake flares this week, Barwork is just getting finished and hope to install in the next few weeks.
I would like to know what is a good scantool to run for this vehicle to check faults and also change the stupid stop/start from resetting? I dont want to install anything permenant really
With a few more kms the exhaust and snorkel will go on with a Dyno tune, not sure what i am going to do with the DPF yet.
Glenn