Front Park Sensors
Posted: Fri Jul 26, 2019 5:53 pm
Hey Guys,
Seeking your thoughts on this.....
Had the PCM updated on Tuesday and since done I have had issues with the inner right sensor.
As you can see in the pic my front plate sticks out from the bar by about 25mm up until the update it has not been an issue, now every time I put the car into reverse or drive I get the beep and straight to red, take the plate off all good, put back on, adjust and away it goes again. Same distance from the sensor to the plate on the left hand side and I have no issue there.
So the question is how can an update affect one sensor and create an issue that wasn't there prior, there are no DTC's in Forscan and I can't see any way to re calibrate them.
Ideas???
Cheers
Jason
Seeking your thoughts on this.....
Had the PCM updated on Tuesday and since done I have had issues with the inner right sensor.
As you can see in the pic my front plate sticks out from the bar by about 25mm up until the update it has not been an issue, now every time I put the car into reverse or drive I get the beep and straight to red, take the plate off all good, put back on, adjust and away it goes again. Same distance from the sensor to the plate on the left hand side and I have no issue there.
So the question is how can an update affect one sensor and create an issue that wasn't there prior, there are no DTC's in Forscan and I can't see any way to re calibrate them.
Ideas???
Cheers
Jason