Page 1 of 1
Hey from Perth
Posted: Sun Oct 29, 2017 12:46 pm
by Zalex2
Hi everyone
I’m Zac located in Perth, just started doing some mods to my px mostaly mods that will benefit my work at a telecommunications technician doing rural work.
Wanting to know if it possible to update the tank size on a px mk1 with forscan yet?
Re: Hey from Perth
Posted: Sun Oct 29, 2017 2:37 pm
by saeb
Zalex2 wrote: ↑Sun Oct 29, 2017 12:46 pm
Hi everyone
I’m Zac located in Perth, just started doing some mods to my px mostaly mods that will benefit my work at a telecommunications technician doing rural work.
Wanting to know if it possible to update the tank size on a px mk1 with forscan yet?
Short answer, no.
I tried one the other week, from Perth actually and I could not write to it with some other software I have. I will check with another local vehicle when time permits or I may ask for some changes in Forscan for manual entry in tank size and see if it writes.
I do not have a time line for this and there is no given that it will even work as the available size could be hard coded into the firmware.
Re: Hey from Perth
Posted: Sat Nov 04, 2017 10:06 am
by Zalex2
No worries, what is the best way to track usage then using a EDD or a scan gauge ?
Re: Hey from Perth
Posted: Sat Nov 04, 2017 2:36 pm
by saeb
May someone else can answer. Put a post in the Scangauge area, I do not use it for that purpose.
Re: Hey from Perth
Posted: Sat Nov 04, 2017 5:37 pm
by GerryP
No idea about EDD but I do run a ScanGauge. I have 'snipped' a page from the booklet re Trip Computers which I think may be what you're looking for.
Cheers
Ooops, sorry, just realised I should have posted this in the Scangauge section...