Ranger Mods

Hi,

On my PX2 Wildtrak the pre collision assist is always set to high every time I start the car. I prefer medium or low I'm wondering if there's a way to permanently change the setting?

Same with the lane assist aid, it is always turned off I would prefer it to be enabled by default if possible?
Thanks

There is no asbuilt change. Mine always stays where I leave it, normal. Not sure if anyone else has had the issue but it is the CCM that controls it so can only suggest a firmware update from Ford and see it there is a later one and resolves it.

You could also share the current calibration level from Forscan in the configuration tab up the top once connected and will suss it out.