Lightforce ROK20 - Light output test
Posted: Fri May 29, 2020 8:27 am
I'm about to fit a couple of Lightforce ROK20 light to my Ranger, one each side mounted to the roof rails, facing sideways.
I did a little test last night and thought it was worth sharing the results for anyone else considering a similar setup.
These lights have a fairly narrow beam as you can see.
Light off:
ROK20 on:
I had considered using these as additional reverse lights too, but when mounted low down (tow bar level) the beam just isnt wide enough. I have some Stedi 7" light bars on their way for that and I'll try and post photos of their light output.
I did a little test last night and thought it was worth sharing the results for anyone else considering a similar setup.
These lights have a fairly narrow beam as you can see.
Light off:
- no light.JPG (89.42 KiB) Viewed 60 times
- no light.JPG (89.42 KiB) Viewed 60 times
ROK20 on:
- ROK20.JPG (162.43 KiB) Viewed 60 times
- ROK20.JPG (162.43 KiB) Viewed 60 times
I had considered using these as additional reverse lights too, but when mounted low down (tow bar level) the beam just isnt wide enough. I have some Stedi 7" light bars on their way for that and I'll try and post photos of their light output.