Page 1 of 1
Weird error when trying to save
Posted: Sun Jul 18, 2021 12:37 pm
by DionN
Hey all
Had a weird error when i was trying to save the BdyCM module. All I was doing was trying to save the config after turning off the tub puddle lamp (removed the rear sports bar) and it gives me some upload error.
Running Win10 using the usb dongle bought off the shop. PX2 DC Auto.
- error1.PNG (18.44 KiB) Viewed 94 times
- error1.PNG (18.44 KiB) Viewed 94 times
- error2.PNG (3.69 KiB) Viewed 94 times
- error2.PNG (3.69 KiB) Viewed 94 times
Re: Weird error when trying to save
Posted: Mon Jul 19, 2021 12:30 pm
by saeb
Is the ignition on?
Re: Weird error when trying to save
Posted: Tue Jul 20, 2021 10:52 am
by DionN
Yes mate, left on - however - I did notice that the radio and dash auto shutoff. Not sure if that matters?
I have successfully changed the start up screen splashback logo so I can do things just not what I'm looking at.
Unless I'm supposed to turn everything on, connect, log into specific module, go through and do what I want, cycle the ignition then perform write? Not sure
Re: Weird error when trying to save
Posted: Thu Jul 22, 2021 3:19 pm
by Griffo17
You don't also have a bluetooth dongle plugged in simultaneously by any chance? this prevented me from writing Tyre circumference in BdyCm
Re: Weird error when trying to save
Posted: Thu Jul 22, 2021 3:22 pm
by DionN
I do have a ultrascan installed in the 2nd plug at the back. I'll give it a go without that plugged in. Cheers.
Re: Weird error when trying to save
Posted: Fri Jul 23, 2021 3:56 pm
by saeb
Good catch Griffo17..
Remove the second device when programming always.
Also if modules are shutting down it can be a sign of low battery state of charge. Although module will program down to 10.2 volts on the bench I do not recommend doing so.