Ranger Mods

Is there a way to change my air con to be on permanent air-recirc. Always find mine switches itself back to outside ai, I live in the country and I always seem to conviently notice when I pass a dead roo

I just disconnected the socket in the recirc door gear-motor. Done.

Programming wise, no.

saeb wrote: ↑Thu Jun 21, 2018 5:48 amProgramming wise, no.

Ah i was going to ask this as i also find it a pain it always changes back to fresh air.

Though there would be a way to disable this for sure

janemar wrote: ↑Thu Jun 21, 2018 1:10 am I just disconnected the socket in the recirc door gear-motor. Done.

Haha dammit why didn’t I think of that solution!!! Doing that first thing in the morning

janemar wrote: ↑Thu Jun 21, 2018 1:10 am I just disconnected the socket in the recirc door gear-motor. Done.

So it defaults to the closed position?

Got a pic as to the location of the plug?

Yes.

...

janemar wrote: ↑Thu Jun 21, 2018 1:10 am I just disconnected the socket in the recirc door gear-motor. Done.

How? Where is it and can you get to it without removing the dash? Thanks.

Lower glove box all the way down and you will see the plug in the side on the box. You will see directly behind the glove box the recirc vent.

If you cannot figure it out turn recirc on and off while watching and you will see it happen.

Still no programming available for the recirc?
Just to lock it in the position it was late set to would be nice, (like the fog lamp memory)

Brett_32i wrote: ↑Sat Oct 12, 2019 12:30 pm Still no programming available for the recirc?
Just to lock it in the position it was late set to would be nice, (like the fog lamp memory)

No, there is no option in abuilt to do so.

So far, the px3 is always staying where I left it with recirc off.
Opposite to the Everest which always defaults to recirc