Hi,
On my PX2 Wildtrak the pre collision assist is always set to high every time I start the car. I prefer medium or low I'm wondering if there's a way to permanently change the setting?
Same with the lane assist aid, it is always turned off I would prefer it to be enabled by default if possible?
Thanks
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Possible to change default Pre-Collision Assist setting?
- saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
There is no asbuilt change. Mine always stays where I leave it, normal. Not sure if anyone else has had the issue but it is the CCM that controls it so can only suggest a firmware update from Ford and see it there is a later one and resolves it.
You could also share the current calibration level from Forscan in the configuration tab up the top once connected and will suss it out.
You could also share the current calibration level from Forscan in the configuration tab up the top once connected and will suss it out.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic