hi
It seems the sync3 in everest has a factory sub in the boot, in the upper models at least which means there must be a "sub out" on the main unit/module
does anyone have wiring output and programming information for this, would be ideal to wire aftermarket amp to this in ranger
thanks
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Factory Sub Out?
-
saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
Just write a UA2 Everest asbuilt to the ACM making sure to backup yours first. Saves a lot of mucking around.
- 2019-11-07 18_50_33-AMP.png (108.76 KiB) Viewed 244 times
- 2019-11-07 18_50_33-AMP.png (108.76 KiB) Viewed 244 times
- 2019-11-07 18_52_04-C4821B.png (250.51 KiB) Viewed 244 times
- 2019-11-07 18_52_04-C4821B.png (250.51 KiB) Viewed 244 times
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic
-
saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
Should do, all ACM can be programmed the same way for this and low outputs if needed.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic