Hi guys.
Anyone knowledgeable with tuning the 3.2 with HP Tuners?
I'd like to be able to log with Forscan the active Mode and Config values to determine the active Injection and Boost tables.
Would those PIDs be available to Forscan, or are they a virtual PID created by HP software to enable their logging and editing?
Any knowledge shared will be greatly appreciated.
Thanks
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
PX2 PCM Mode & Config PIDs
-
CatHerder
- Donator
- Posts: 159
- Joined: Mon Apr 22, 2019 12:02 am
- Location: Canberra
- Model Of Vehicle: RANGER XLT PX3
- Year Of Vehicle: 2019
- Forscan Dongle Type: OBDlink MX Black Bluetooth
- Has thanked: 14 times
- Been thanked: 39 times
FORscan logging is very good, but not for the info you're after. Use the HPT Scanning tool. The SID208 has quite limited pid support vs SID209 (DPF) but even HPT does not explicitly call out which table sets are active at a particular time.
Ian B
PX3 XLT 3.2
PX3 XLT 3.2
-
saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
I guess we all look at same thread over there assuming we are talking about a 2012 .
There are no PIDs for what you require. What you are after is generally read directly from ram, most likely using service 0x23 so write some software get and a2l and plausible get an answer.
If it is a PX2 2016 though then it is a SID 209 pre and post DPF.
There are no PIDs for what you require. What you are after is generally read directly from ram, most likely using service 0x23 so write some software get and a2l and plausible get an answer.
If it is a PX2 2016 though then it is a SID 209 pre and post DPF.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic