Steering Angle value missing
Posted: Sun Jul 02, 2017 7:54 pm
Hi Stewart!
Just noticed that my steering angle values suddenly disappeared.
Things I done via Forscan,
1. Reset the error - something like a low voltage in module, forgot the exact code.
2. Reset PSCM module and run a service test. All pass good.
3. No error so far.
But still, values wont reappear and wont change even I move the steering wheel. I noticed that the motor won't stop giving assist too even at the end of the lock. This is porbably because the module is blind on the actual steering angle since it is stuck at 720degrees.
EDIT:
ABS_STEERING ANGLE VALUE works fine. Value is okay and calibrated.
Does ABS and PSCM use different str. angle sensors?
Just noticed that my steering angle values suddenly disappeared.
Things I done via Forscan,
1. Reset the error - something like a low voltage in module, forgot the exact code.
2. Reset PSCM module and run a service test. All pass good.
3. No error so far.
But still, values wont reappear and wont change even I move the steering wheel. I noticed that the motor won't stop giving assist too even at the end of the lock. This is porbably because the module is blind on the actual steering angle since it is stuck at 720degrees.
EDIT:
ABS_STEERING ANGLE VALUE works fine. Value is okay and calibrated.
Does ABS and PSCM use different str. angle sensors?