Hi guys,
I have had px3 lights put on my px2. Headlights (HID) flicker on start up and come good after a little driving. Battery is good (12.6ish). Heard that dlr's need to be off as they draw power and wont allow the hid to start. They have been wired into the wiper motor so on ignition, key on they r on.
Thank you.
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Px3 headlight on Px2
-
Daleblogg01
- New Member
- Posts: 2
- Joined: Tue Feb 13, 2018 4:55 pm
- Location: Darwin
- Model Of Vehicle: RANGER WILDTRAK PX2
- Year Of Vehicle: 2016
-
saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
Assuming you also used the headlight control module? you should not have any issues. If you have not added this then this is probably why.
You would be best to wire it factory if possible as it rules out all pretty much every issue you will face. You would be best get hold of the wiring diagrams and do the install properly.
Basically if I look at adding modules from newer vehicle or to vehicle where the module did not exist before then I wire it per factory and use all factory modules as per the diagrams. I have never had an issue following these rules.
You would be best to wire it factory if possible as it rules out all pretty much every issue you will face. You would be best get hold of the wiring diagrams and do the install properly.
Basically if I look at adding modules from newer vehicle or to vehicle where the module did not exist before then I wire it per factory and use all factory modules as per the diagrams. I have never had an issue following these rules.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic
