Hi all,
Setting up a mine spec ute, is there a way with forscan to have headlights come on with ignition? Looking to avoid fitting a KOLO module.
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
PX3 KOLO (Key on Lights On)
-
- Donator
- Posts: 199
- Joined: Fri May 26, 2017 9:52 pm
- Has thanked: 53 times
- Been thanked: 38 times
Leave the headlight switch in the on position?
-
- Donator
- Posts: 159
- Joined: Mon Apr 22, 2019 12:02 am
- Location: Canberra
- Model Of Vehicle: RANGER XLT PX3
- Year Of Vehicle: 2019
- Forscan Dongle Type: OBDlink MX Black Bluetooth
- Has thanked: 14 times
- Been thanked: 39 times
I assume you don't care about tail lights?
There is a DRL LAMP CIRCUIT USAGE entry for the BCM. By default it is set to DRL ONLY on an XLT/WT. I'm unable to check, but It's possible that LOW BEAM (or similar) is an available option.
Edit:
There is a DAYTIME RUNNING LAMPS entry too, which is set to DEDICATED DRL for an XLT.
Good luck.
There is a DRL LAMP CIRCUIT USAGE entry for the BCM. By default it is set to DRL ONLY on an XLT/WT. I'm unable to check, but It's possible that LOW BEAM (or similar) is an available option.
Edit:
There is a DAYTIME RUNNING LAMPS entry too, which is set to DEDICATED DRL for an XLT.
Good luck.
Ian B
PX3 XLT 3.2
PX3 XLT 3.2
- saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
Enable DRL and set low beam as DRL lights.
Also enable use parkers with DRL so the rear taillights are on.
Pretty sure the base cluster should support the DRL menu to support this.
Also enable use parkers with DRL so the rear taillights are on.
Pretty sure the base cluster should support the DRL menu to support this.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic