Default DTC
Posted: Sun May 30, 2021 2:04 pm
2016 3.2 XLS ranger. 70,000km
Was on the highway the other day, 400km into a 700km drive when out of the blue I get "Hill Decent control failed, DSC error service required on the dash display.
Figuring perhaps a speed sensor error i pulled over and plugged in my code reader and the only code was for Cyl 4 glowplug.
Cleared it, shut down and restarted the vehical and all good everthing back to normal. Have since done another 1600km without any DTC codes going off again.
Is the Hill decent, DSC error just the default DTC error that flashes up on the dash display for any active or logged DTC?
Vehical has been started from dead cold half dozen times now without another glowplug fault going off? Now i don't even know if it's worth chasing or the CanBus just had a split second spaz and chucked a code up.
Was on the highway the other day, 400km into a 700km drive when out of the blue I get "Hill Decent control failed, DSC error service required on the dash display.
Figuring perhaps a speed sensor error i pulled over and plugged in my code reader and the only code was for Cyl 4 glowplug.
Cleared it, shut down and restarted the vehical and all good everthing back to normal. Have since done another 1600km without any DTC codes going off again.
Is the Hill decent, DSC error just the default DTC error that flashes up on the dash display for any active or logged DTC?
Vehical has been started from dead cold half dozen times now without another glowplug fault going off? Now i don't even know if it's worth chasing or the CanBus just had a split second spaz and chucked a code up.