Ranger Mods

andrew1918 wrote: ↑Wed May 24, 2017 7:54 pm Hi Stewart

The front parking sensors parts arrived.
I had install the wiring and the sensor ,replace the switch and reprogram the computer,
After that,i lost the symbol on the screen when I doing reverse,(I think i lost rear parking sensors too) also I cannot switch off from the right manual only from the switch
Do you have any idea?

andrew1918 wrote: ↑Sat May 27, 2017 5:22 pm i using the PAM code you provided
"736-01-01 388D-113A-4F
736-02-01 4403-0900-90
736-03-01 0400-2200-67
736-04-01 0040-200A-AC
736-05-01 1840-0000-AC"

I change back to default the symbol returned and I can switch off the rear parking sensor in the right manual when I doing the reverse .

saeb wrote: ↑Sat May 27, 2017 7:02 pm

andrew1918 wrote: ↑Sat May 27, 2017 5:22 pm i using the PAM code you provided
"736-01-01 388D-113A-4F
736-02-01 4403-0900-90
736-03-01 0400-2200-67
736-04-01 0040-200A-AC
736-05-01 1840-0000-AC"

I change back to default the symbol returned and I can switch off the rear parking sensor in the right manual when I doing the reverse .

Pretty sure the asbuilt I gave you was off 2017 XLS.

I will need to purchase a switch and sensors to look further. Also, even though the wiring is at the BCM for the switch it may not follow all the way through to the switch. I can only test once I buy the parts.

Honestly I don't even need front sensors so it is pretty low on the list while I put the existing dollars towards pitch roll.

andrew1918 wrote:give me your address ,I can post the switch ,wiring and sensors to you.