Hi all,
I’m looking to install an on board compressor (arb twin) and a winch.
Which of the posts on the positive terminal should be used for these loads? My dual battery uses the b+ terminal, but that it already pretty heavily loaded with terminals for the uhf, spotlights, charger etc, probably beyond fords 2.5mm recommendation.
Thanks,
JP
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Positive terminal for compressor and winch
- RossPat
- Moderator
- Posts: 1409
- Joined: Wed Apr 04, 2018 9:33 pm
- Location: Adelaide
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2018
- Forscan Dongle Type: OBDlink MX Black Bluetooth
- Has thanked: 32 times
- Been thanked: 225 times
On the post would be the best one for load.
Move the lighter load gear elsewhere
Move the lighter load gear elsewhere
2018 XLT PX2 in Winning Blue
- saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
I'm using terminals as below as they are the most accessible.
Just do not use the one with the 225 amp mega fuse on is all and the other side of that fuse which could be used is far to difficult to utilise with large cable.
Just do not use the one with the 225 amp mega fuse on is all and the other side of that fuse which could be used is far to difficult to utilise with large cable.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic