Ranger Mods

Hi All, I have recently swapped out the Sync 2 in my 2016 Wildtrak to Sync 3 and have been really lucky in that most things have just worked - the only issue I have is that my parking sensors do not visualise on the new screen, I just get audible beeps as I should but would like to enable as in the picture.

Any ideas on which settings I need to adjust?

Thanks folks.

Have you tried writing Sync3 asbuilt from a 2017 2018 Ranger Sync3 of the same model type? If you get a local VIN then download from motorcraft and write that one. Make sure it is auto or manual to suit.

Hi, try with this data;

Required: APIM As-Built Data Modifications:

Enable Object Detection for Rear View Camera (Car Icon In Top Right Corner)
7D0-01-01 xXxx xxxx xxxx
- Change value from a 2 to an A

Enable Flank Guard (On Screen Object Detection for All Sensors When Driving Slowly)
7D0-02-02 xXxx xxxx xxxx
- Change value from a 2 to a 3