Hi guys,
I have a 2013 PX XL and have fitted a few XLT items.
I installed the driving lights and had to get them "activated" by ford in the Pre Delivery settings.
Ive since fitted an XLT locker diff and want to know if anyone on here could point me in the direction of getting this "activated" in the BCM settings (similar to the driving lights).
I'm fairly confident that's it will be similar as the diff lock light is actually in the dash, as was the driving lights one.
Could someone here connect up to my car to check this?
I'm in Melbourne
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Hi all, new to the forum
-
- New Member
- Posts: 2
- Joined: Wed Sep 13, 2017 6:03 pm
- Location: Melbourne
- Model Of Vehicle: RANGER XLS PX
- Year Of Vehicle: 2013
- saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
Brings back memories from a Facebook post regarding the same question............ Think some heads butted.
Have you wired it to the vehicle as per the XLT wiring diagrams?
Have you brought the correct console switch?
Have you wired the console switch correctly the the correct module?
There is an option in the PX1 CCC programming to change from open style rear axle to limited or locking. Whether this will influence everything else that goes along with it is unknown as I have not done it. The same questions above would still apply anyway.
Have you wired it to the vehicle as per the XLT wiring diagrams?
Have you brought the correct console switch?
Have you wired the console switch correctly the the correct module?
There is an option in the PX1 CCC programming to change from open style rear axle to limited or locking. Whether this will influence everything else that goes along with it is unknown as I have not done it. The same questions above would still apply anyway.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic
-
- New Member
- Posts: 2
- Joined: Wed Sep 13, 2017 6:03 pm
- Location: Melbourne
- Model Of Vehicle: RANGER XLS PX
- Year Of Vehicle: 2013
Hi, thanks for your reply. I have wired it as close to factory as possible. Instead of the factory switch grounding the locker wire, Ive rigged up a relay to activate the locker but would like it to come up on the dash. I know the dash light is there as it comes on when you run the cluster self test.
I really believe this is the same case as the driving lights. Just needs to be activated, and then the correct wire used to ground via switch for it to work like factory. I just need someone to turn on the damn thing via WDS or Forscan
I really believe this is the same case as the driving lights. Just needs to be activated, and then the correct wire used to ground via switch for it to work like factory. I just need someone to turn on the damn thing via WDS or Forscan
-
- New Member
- Posts: 1
- Joined: Tue Sep 11, 2018 11:33 pm
- Location: THA
- Model Of Vehicle: RANGER WILDTRAK PX2
- Year Of Vehicle: 2016
Hello
I am a new member from Thailand.
I am a new member from Thailand.