Ranger Mods

How can u change so its always ontop

Pacman1311 wrote: ↑Wed Dec 09, 2020 5:28 pm How can u change so its always ontop

You can't, it will always change back to the default keyboard.

Following

There was a time when Qwerty would stay on unless the battery is disconnected and you could type into the unit while driving.

At some point in time if you car had a sync update by Ford you would lose those two functions. My car has never had a sync update so I still have them.

As per a post on another thread, see below, Stuart can get you back Qwerty.

Post by saeb » Sun Aug 16, 2020 12:58 am
Pull it out, post it to me an Walah, default qwerty keyboard.

Basically anything before 3.0 was ok, eg 2.2.

I changed my language to English (Aus) and it stays that way

PXXLTWA wrote: ↑Wed Dec 30, 2020 4:41 pm I changed my language to English (Aus) and it stays that way

That is normal but the Qwerty keyboard doesn't stay.

I don't have the latest version of Sync 3 so I have now gathered that it goes when you update the software?

speaking of which,

I have a ELM327 wifi reader and have Forscanlite on IOS, also have it on a PC.

Unsure how to find silent mode in any menus in the above Apps and also on PC, I can connect to the Sync 3 on PX2 XLT with tech pack and read a bunch of data but silent mode doesn't show up anywhere?

PXXLTWA wrote: ↑Thu Dec 31, 2020 12:52 am I don't have the latest version of Sync 3 so I have now gathered that it goes when you update the software?

speaking of which,

I have a ELM327 wifi reader and have Forscanlite on IOS, also have it on a PC.

Unsure how to find silent mode in any menus in the above Apps and also on PC, I can connect to the Sync 3 on PX2 XLT with tech pack and read a bunch of data but silent mode doesn't show up anywhere?

It is quite possible that your dongle can't read all the modules.
If you have a licensed copy of Forscan and a correct dongle it should work.

I think you are correct. I’ve read a few posts now and seen screen shots and I definitely don’t have the BCM control menu at the top.

PXXLTWA wrote: ↑Thu Dec 31, 2020 12:02 pm I think you are correct. I’ve read a few posts now and seen screen shots and I definitely don’t have the BCM control menu at the top.

You need the fully licensed Windows version of Forscan to make changes
https://forscan.org/download.html