Hi guys, have a few questions on wiring before I pull the car apart and reinvent the wheel. 01/2018 Everest Titanium
1st. Mounting a CB aerial on front, and want to run the wire into the cab, and end up around the glovebox area. No plug on end, so just bare cable. Best place to get that in cab?
2nd. Also mounted a light bar. One of those pre-wired with switch. Are there any spare plugs/connection in the engine bay to use for the bar? best place to get the switch into the cabin? Mounting ideas for the switch?
3rd: I need to run a small coax cable from near tow hitch to the dash, for a video camera on my caravan. Any pre-existing wiring that would help? If not, best route for the wiring and cab entry?
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Wiring info (route and cab entry)
-
- Donator
- Posts: 51
- Joined: Thu Jul 04, 2019 8:19 am
- Location: Thornlie, WA
- Model Of Vehicle: EVEREST TITANIUM UA
- Year Of Vehicle: 2018
- Forscan Dongle Type: OBDlink MX Black Bluetooth
- Been thanked: 5 times
Regards
Alan 'Moby' Stuart
========================================
2018 UA Everest Titanium in Shadow Black
Alan 'Moby' Stuart
========================================
2018 UA Everest Titanium in Shadow Black
-
- Donator
- Posts: 48
- Joined: Wed Jun 12, 2019 8:51 pm
- Location: Langwarrin
- Model Of Vehicle: EVEREST TREND UA
- Year Of Vehicle: 2018
- Has thanked: 1 time
- Been thanked: 2 times
For 3, remove inner boot tool well.
Under there you will find a gromet for camera cable.
Start at dash end running the cable.
Door trims pop off so cable just lays underneath. Then tuck it under trim next to rear passenger.
Under there you will find a gromet for camera cable.
Start at dash end running the cable.
Door trims pop off so cable just lays underneath. Then tuck it under trim next to rear passenger.
2018 Everest
2019 Ranger
2019 Ranger
-
- Donator
- Posts: 51
- Joined: Thu Jul 04, 2019 8:19 am
- Location: Thornlie, WA
- Model Of Vehicle: EVEREST TITANIUM UA
- Year Of Vehicle: 2018
- Forscan Dongle Type: OBDlink MX Black Bluetooth
- Been thanked: 5 times
ThanksBrett_32i wrote:For 3, remove inner boot tool well.
Under there you will find a gromet for camera cable.
Start at dash end running the cable.
Door trims pop off so cable just lays underneath. Then tuck it under trim next to rear passenger.
Sent from my SM-T835 using Tapatalk
Regards
Alan 'Moby' Stuart
========================================
2018 UA Everest Titanium in Shadow Black
Alan 'Moby' Stuart
========================================
2018 UA Everest Titanium in Shadow Black