Ranger Mods

Hi guys, have a few questions on wiring before I pull the car apart and reinvent the wheel. 01/2018 Everest Titanium

1st. Mounting a CB aerial on front, and want to run the wire into the cab, and end up around the glovebox area. No plug on end, so just bare cable. Best place to get that in cab?

2nd. Also mounted a light bar. One of those pre-wired with switch. Are there any spare plugs/connection in the engine bay to use for the bar? best place to get the switch into the cabin? Mounting ideas for the switch?

3rd: I need to run a small coax cable from near tow hitch to the dash, for a video camera on my caravan. Any pre-existing wiring that would help? If not, best route for the wiring and cab entry?

For 3, remove inner boot tool well.
Under there you will find a gromet for camera cable.
Start at dash end running the cable.
Door trims pop off so cable just lays underneath. Then tuck it under trim next to rear passenger.

Brett_32i wrote:For 3, remove inner boot tool well.
Under there you will find a gromet for camera cable.
Start at dash end running the cable.
Door trims pop off so cable just lays underneath. Then tuck it under trim next to rear passenger.

Thanks

Sent from my SM-T835 using Tapatalk