Ranger Mods

Hi,

Ive seen it on other models but not on a Ranger, is it possible to enable showing all 4 TPMS pressure values on the dash? (ie pic of vehicle on screen with 4 wheels and 4 pressures)

Theres a few videos showing changing the IPC AsBuilt 720-04-01 to x4xx xxx xxxx but not sure what will be required for a Ranger. Factory it was x0xx xxx xxx, i tested x4xx xxx xxx and no luck.

Obviously yes my vehicle has TPMS (2017 PX MK2 Wildtrak) and can view the pressures in forscan.

Also if its possible, to show 'Specified Pressure' were it shows 'Specified 40' for example showing your desired pressure, again seen it set as 720-04-01 to xx8x xxx xxx but not sure what would be required for a Ranger.

Thanks

The menu does not exist in the firmware so cannot be enabled.

I did flash some Euro Modeo firmware and could display the individual readings but being that the firmware was built for LHD is was pretty pointless.

Ah, no worries, thanks Stewart

bumping this one up! Any idea if newer versions of the firmware support TPMS readings for each wheel?

p3t0r wrote: ↑Sat Oct 06, 2018 7:36 pm bumping this one up! Any idea if newer versions of the firmware support TPMS readings for each wheel?

Havent seen a PXIII but I believe they have the gauge for individual now.

There is currently no available downloadable firmware for the current clusters.

hey guys ...
that is actually coming up on a European forum.
Any thoughts on that one?
The author wrote that it is out of a video which is showing a ranger ...

Best regards,
Luca

Which forum is this? Thanks.

dexxger wrote: ↑Wed Nov 21, 2018 10:26 pm hey guys ...
that is actually coming up on a European forum.
Any thoughts on that one?
The author wrote that it is out of a video which is showing a ranger ...

58AD0D10-C09B-4A27-87F8-461251CCD0AA.jpeg


Best regards,
Luca

Its PX3 not PX2.

PX3 IPC has the menu in the firmware where PX2 does not. Firmware is not available at this time.