Hello guys,
Went through a guy to order a unichip for my T7(predpf) model. However the guy tried to install it himself and made a mess under the bonnet with cables here and there. Is there anyone here who knows how can i access the ecu and where to place the unichip modules? There are 2 modules, the q4 and the idriver module and 2 huge « blocks » which piggybacks on the ecu original cables.
A picture will suffice as i’ll try to do it myself.
Thanks guys.
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Fitting of Unichip
- saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
ECU pretty much has to come out. It is under the engine bay fuse box and sucks to get to it. Honestly fitting a Unichip is not a fun job. The bracket was mounted near the ABS module but that is the best info I can give as my photos are long gone.
One big thing to note. Do not use it unless the vehicle it came off used the same PCM calibration as yours does. The Unichip you bought was based on the previous vehicles calibration, if yours is anything but then the tune will most likely be way off and will need to be re tuned ona dyno.
This is the main reason I got rid of it and got a flash tune in the end.
One big thing to note. Do not use it unless the vehicle it came off used the same PCM calibration as yours does. The Unichip you bought was based on the previous vehicles calibration, if yours is anything but then the tune will most likely be way off and will need to be re tuned ona dyno.
This is the main reason I got rid of it and got a flash tune in the end.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic