Help! Swapped sync 2 to 3 everything works apart from reverse camera.
Its enabled in Forscan.
Also when select reverse (manual) the park sensors activate so the switch/wiring knows vehicle is in reverse.
Fuses all look ok.
Wildtrak to Wildtrak Apim so reverse camera should be standard.
Cheers
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Sync 2 to 3 upgrade, Reverse camera doesn't work
- saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
Have replied to your PM, if that resolves it post the outcome here.m_attt wrote: ↑Mon Oct 28, 2019 5:01 am Help! Swapped sync 2 to 3 everything works apart from reverse camera.
Its enabled in Forscan.
Also when select reverse (manual) the park sensors activate so the switch/wiring knows vehicle is in reverse.
Fuses all look ok.
Wildtrak to Wildtrak Apim so reverse camera should be standard.
Cheers
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic
-
- Donator
- Posts: 92
- Joined: Mon Mar 04, 2019 9:08 am
- Location: Plymouth UK
- Model Of Vehicle: RANGER WILDTRAK PX2
- Year Of Vehicle: 2016
- Forscan Dongle Type: Other
- Has thanked: 3 times
- Been thanked: 16 times
Pic says it all, Thanks Saeb
Guessing it was mines manual, apim was auto and use a diff signal to trigger the camera when put in reverse.
New asbuilt loaded and all works.
Guessing it was mines manual, apim was auto and use a diff signal to trigger the camera when put in reverse.
New asbuilt loaded and all works.
SnapOn Verus Edge 18.2
-
- New Member
- Posts: 3
- Joined: Tue Jul 27, 2021 9:34 pm
- Location: Sydney
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
Hey fellas, I’ve just upgraded my Sync 2 to Sync 3 and I’m having the same dramas with rear camera not displaying — Ranger’s a manual too so pretty confident apim is auto
What exactly did you change on forscan to get it going?
Cheers
What exactly did you change on forscan to get it going?
Cheers
- saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
Start a fresh user profile in Forscan.
Read APIM non asbuilt, scroll down near the bottom and look for the word Automatic on the right hand column. Change it to manual, write and done.
I cannot look up the naming convention right now but there is only one that will have Automatic showing.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic