Sync 2 to 3 upgrade, Reverse camera doesn't work

m_attt · Mon Oct 28, 2019 5:01 am

Help! Swapped sync 2 to 3 everything works apart from reverse camera.

Its enabled in Forscan.

Also when select reverse (manual) the park sensors activate so the switch/wiring knows vehicle is in reverse.

Fuses all look ok.

Wildtrak to Wildtrak Apim so reverse camera should be standard.

Cheers

Wed Oct 30, 2019 8:27 pm

m_attt wrote: ↑Mon Oct 28, 2019 5:01 am Help! Swapped sync 2 to 3 everything works apart from reverse camera.

Its enabled in Forscan.

Also when select reverse (manual) the park sensors activate so the switch/wiring knows vehicle is in reverse.

Fuses all look ok.

Wildtrak to Wildtrak Apim so reverse camera should be standard.

Cheers

Have replied to your PM, if that resolves it post the outcome here.

m_attt · Wed Oct 30, 2019 9:48 pm

Pic says it all, Thanks Saeb

Guessing it was mines manual, apim was auto and use a diff signal to trigger the camera when put in reverse.

New asbuilt loaded and all works.

: 15724323025615001302490553258510.jpg (2.63 MiB) Viewed 212 times

: 15724323025615001302490553258510.jpg (2.63 MiB) Viewed 212 times

Okarsen · Sat Jun 04, 2022 6:20 pm

Hey fellas, I’ve just upgraded my Sync 2 to Sync 3 and I’m having the same dramas with rear camera not displaying — Ranger’s a manual too so pretty confident apim is auto

What exactly did you change on forscan to get it going?

Cheers

Mon Jun 06, 2022 5:47 am

Okarsen wrote: ↑Sat Jun 04, 2022 6:20 pm Hey fellas, I’ve just upgraded my Sync 2 to Sync 3 and I’m having the same dramas with rear camera not displaying — Ranger’s a manual too so pretty confident apim is auto

What exactly did you change on forscan to get it going?

Cheers

Start a fresh user profile in Forscan.

Read APIM non asbuilt, scroll down near the bottom and look for the word Automatic on the right hand column. Change it to manual, write and done.
I cannot look up the naming convention right now but there is only one that will have Automatic showing.