Hi all,
Im looking at installing a electric wildtrak roller to a px3 wildtrak (pre electric roller), my vehicle doesnt have the module needed to make it work.
My question is can i purchase one of saebs remote start module and re-wire the output to get it to open and close a wildtrak roller, with the unlock, lock, unlock sequence?
Any other ideas are welcomed
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Remote start module
- saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
No the module will not allow it.
Would take a fair bit of investigating but I will assume the electric roller will have a rear tailgate module in it which could be wired to the BCM then with additional BCM programming and a new set of 3 button remotes it would work.
It is not something I can test or really investigate further unless I were to RnD on aa vehicle I have here with the components though. It is more something I would spend the time on in my own vehicle then post the outcome.
Would take a fair bit of investigating but I will assume the electric roller will have a rear tailgate module in it which could be wired to the BCM then with additional BCM programming and a new set of 3 button remotes it would work.
It is not something I can test or really investigate further unless I were to RnD on aa vehicle I have here with the components though. It is more something I would spend the time on in my own vehicle then post the outcome.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic