Hi folks, I searched for Sleep settings on here but could not find answers to this.
I have an 21.25 Everest and fitted a Scanguage 2 to it. It goes to sleep when auto stop is turning the car off when at traffic lights etc and that is fine but on a recent 3 hour trip at started to Sleep whilst we were still moving. Is this caused by lower charging voltage & if so can I set it lower to say 12.5 volts & are there issues doing this? If it press the home button it wakes up again for some time. Thanks in advance. Cheers Rob
Information: Following the announcement on October 23, 2023, this site has been archived as of July 1, 2024. For further details, visit this page.
Scanguage2 sleep mode settings
-
GerryP
- Moderator
- Posts: 514
- Joined: Sun May 21, 2017 8:17 pm
- Location: Karoonda SA
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2017
- Forscan Dongle Type: OBDlink MX+ Black Bluetooth
- Has thanked: 58 times
- Been thanked: 82 times
I have a 2017 XLT and before I turned on Dual Battery mode (turn smart charge off) the voltage would vary fro 15 volts to as low as 12 volts depending on engine load. I would suggest switching Dual Battery mode on. It will most likely fix your issue but also be much kinder to your battery.
Gerry
'17 Ford Ranger PX2 XLT Supercab
Manual, Canopy, Flares, ROH Assassins, Smartbar Stealth, Solar & Dual Battery
'17 Ford Ranger PX2 XLT Supercab
Manual, Canopy, Flares, ROH Assassins, Smartbar Stealth, Solar & Dual Battery
-
saeb
- Site Admin
- Posts: 4169
- Joined: Wed May 17, 2017 8:50 pm
- Location: Seaford VIC
- Model Of Vehicle: RANGER XLT PX2
- Year Of Vehicle: 2015
- Forscan Dongle Type: Ford VCM
- Has thanked: 295 times
- Been thanked: 1063 times
Scangauge may be looking for RPM. Have you emailed Scangauge directly as their response time it generally very good.
Stewart
Ford PX2 Supercab 2015 Automatic
Ford PX2 Supercab 2015 Automatic