Page 1 of 1
Sync 2 to 3 upgrade, Reverse camera doesn't work
Posted: Mon Oct 28, 2019 5:01 am
by m_attt
Help! Swapped sync 2 to 3 everything works apart from reverse camera.
Its enabled in Forscan.
Also when select reverse (manual) the park sensors activate so the switch/wiring knows vehicle is in reverse.
Fuses all look ok.
Wildtrak to Wildtrak Apim so reverse camera should be standard.
Cheers
Re: Sync 2 to 3 upgrade, Reverse camera doesn't work
Posted: Wed Oct 30, 2019 8:27 pm
by saeb
m_attt wrote: ↑Mon Oct 28, 2019 5:01 am
Help! Swapped sync 2 to 3 everything works apart from reverse camera.
Its enabled in Forscan.
Also when select reverse (manual) the park sensors activate so the switch/wiring knows vehicle is in reverse.
Fuses all look ok.
Wildtrak to Wildtrak Apim so reverse camera should be standard.
Cheers
Have replied to your PM, if that resolves it post the outcome here.
Re: Sync 2 to 3 upgrade, Reverse camera doesn't work
Posted: Wed Oct 30, 2019 9:48 pm
by m_attt
Pic says it all, Thanks Saeb
Guessing it was mines manual, apim was auto and use a diff signal to trigger the camera when put in reverse.
New asbuilt loaded and all works.
- 15724323025615001302490553258510.jpg (2.63 MiB) Viewed 214 times
- 15724323025615001302490553258510.jpg (2.63 MiB) Viewed 214 times
Re: Sync 2 to 3 upgrade, Reverse camera doesn't work
Posted: Sat Jun 04, 2022 6:20 pm
by Okarsen
Hey fellas, I’ve just upgraded my Sync 2 to Sync 3 and I’m having the same dramas with rear camera not displaying — Ranger’s a manual too so pretty confident apim is auto
What exactly did you change on forscan to get it going?
Cheers
Re: Sync 2 to 3 upgrade, Reverse camera doesn't work
Posted: Mon Jun 06, 2022 5:47 am
by saeb
Okarsen wrote: ↑Sat Jun 04, 2022 6:20 pm
Hey fellas, I’ve just upgraded my Sync 2 to Sync 3 and I’m having the same dramas with rear camera not displaying — Ranger’s a manual too so pretty confident apim is auto
What exactly did you change on forscan to get it going?
Cheers
Start a fresh user profile in Forscan.
Read APIM non asbuilt, scroll down near the bottom and look for the word Automatic on the right hand column. Change it to manual, write and done.
I cannot look up the naming convention right now but there is only one that will have Automatic showing.